67
Settings and Adjustments
Controlling the TV
You can control your TV using the buttons below when
you set the TV/DVD switch to TV.
By pressing
?/1
TV/VIDEO
VOL
CH (RMT-D122E)
PROG (RMT-D122O)
WIDE MODE
Number buttons, -/--
and ENTER*
* RMT-D122O only
Notes
• Depending on the TV, you may not be able to control your TV
or to use some of the buttons above.
• If you use number buttons to select the TV’s programme
position, press -/-- followed by the number buttons for two-
digit numbers. (RMT-D122O only)
You can
Turn the TV on or off
Switch the TV’s input source between
the TV and other input sources
Adjust the volume of the TV
Select the channel (program position)
of the TV
Switch to or from the wide mode of a
wide TV.
Select the programme of the TV
Controlling AV receivers (amplifiers) with
the remote
1 Slide the TV/DVD switch to DVD.
2 Hold down ?/1, and enter your AV receiver’s
manufacturer’s code (see the table) using the
number buttons. Then release ?/1.
Code numbers of controllable AV receivers
(amplifier)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
AV receiver (amplifier).
Manufacturer Code number
Sony 91 (default), 89
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sansui 87
Technics 97, 98
Yamaha 94, 95, 96
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
1
4
7
2
5
8
0
3
6
9
-
?/1 (on/standby)
button
Number
buttons
TV/DVD
switch
Number
buttons*
TV/DVD
switch
1
4
7
2
5
8
0
3
6
9
-
-/--*
TV/VIDEO
VOL
CH/PROG
ENTER
ENTER*
WIDE MODE
?/1 (on/standby)
button
