A SERVICE OF

logo

Regency
®
E33S-1 Sunrise Gas Insert 27
MAINTENANCE
10) Remove the fan access plate by undoing the 12 screws shown.
11) Remove the 2 screws that hold the pilot assembly in place and lift
forward as shown below.
12) Remove the 2 screws that hold the fan in place and slide the fan
towards the front of the unit.
13) Unplug the 2 connector wires highlighted below.
14) Lift up the left side of the fan and disconnect the ground wire shown.
15) Remove the fan from the unit by carefully lifting up and ensure not to
damage the pilot assembly.
16) Replace fan and reverse steps.
MAINTENANCE