10 EN
FUNCTION OVERVIEW
(*) The unit can also be turned on by pressing these buttons.
1. I /Q ON/STANDBY button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely shut down the unit,
you must unplug the AC power cord)
2. ST ANDBY indicator
•This indicator lights up in red when the unit
is in
standby mode and turns off when the unit is active.
3. CD indicator
•This indicator lights up in green when a CD is inserted.
4. BD indicator
•This indicator lights up in blue when a Blu-ray Disc is
inserted.
5. DVD indicator
•This indicator lights up in orange whe n a DVD is inserted.
6. In frared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
7. Disc tray
• Place a disc when opening the disc tray.
8. Display
• Refer to “Front Panel Display” on page 13.
9. A (open/close) button*
• Press
to open or close the disc tray.
10. SD CARD slot
• Insert an SD Memory Card, and play back the
contents in it.
11. F (pause) button
• Press to pause playback.
12. C (stop) button
• Press to stop playback.
13. B (play) button*
• Press to start or resume playback.
14. H/G (skip down/up) buttons
• Press to skip to the previous or next title / chapter /
track / file.
1. AC INLET terminal
• Use to connect the AC outlet with the AC cord.
2. AUDIO OUTPUT (DIGITAL OPTICAL/COAXIAL) jacks
• Use to
connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio optical/coaxial input jack with a digital audio
optical/coaxial cable.
3. VIDEO OUTPUT (COMPONENT) jacks
• Use to connect a TV or AV receiver with component
video inputs with an RCA component video cable.
4. VIDEO OUTPUT (VIDEO) jack
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
5. IR IN jack
• A commercially available IR receiver can be
connected to the IR IN jack,
allowing you to control
the BD player when it’s out of sight, for example,
installed in a cabinet.
6. IR OUT jack
• A commercially available IR emitter can be
connected to the IR OUT jack to pass IR (infrared)
remote control signals al
ong to other components.
7. CONTROL CONNECTOR (RS-232)
•This bidirectional RS-232 port can be connected to an
external controller.
8. AUDIO OUTPUT (ANALOG) jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
9. ETHERNET terminal
• Use to connect a telecommunications equipment
with LAN cable.
10.HDMI OUT jack
• Use to connect a TV, an AV receiver / amplifi er or other
device with an HDMI com patible port with an HD M I cable.
Front Panel
731 62 9*111213*10 1484 5
Rear Panel
IR
IN
RS232
428731
109
5
6
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
•This unit does not have the RF modulator.
