19
Using a Headset
Note: Your system administrator may have enabled full-time headset operation
on your telephone. Telephones with full-time headset operation enabled must be
operated only with headsets.
Telephones that are not programmed for full-time headset operation will provide
a HEADSET key to allow you to switch between handset and amplified headset
(no feature control switch) operation.
Switching between handset and headset mode when using a Headset with
Feature Control Switch can be accomplished by connecting or disconnecting the
headset at the quick-disconnect plug on the headset cord, but you should also
disable headset operation if the handset will be used for an extended period of
time.
A headset can be used either in regular answer mode or with the Auto Answer
feature programmed.
Most headsets are installed using the same jack that the handset plugs into.
Mitel Networks Headsets with Feature Control Switch (PN 9132-800-500-NA/
9132-800-501-NA) plugs into the dedicated headset jack (the jack nearest the
front of the set).
To Install a Headset (no Feature Control Switch)
To install the headset for your use, perform the following tasks:
1.When the telephone is not in use, lift the handset from the cradle and
carefully turn the set upside down.
2.Unplug the handset cord where it connects to the telephone.
3.Plug in the headset cord in the same place.
4.Set the telephone upright and press the Headset Feature Key.
5.Store your handset in a safe place.
