47
Appendix A:
Common Problems and Solutions
Wireless-G PrintServer for USB 2.0
7. To start over, I need to set the PrintServer to its factory default settings.
Unplug the PrintServer’s power adapter. Press the Reset button while you plug in the PrintServer’s power
adapter. Continue to hold the Reset button for 10 seconds and then release it. This will reset the password,
wireless, and other settings on the PrintServer to the factory defaults. In other words, the PrintServer will
revert to its original factory configuration.
8. I need to upgrade the firmware.
In order to upgrade the firmware with the latest features, you need to go to the Linksys website and download
the latest firmware at www.linksys.com.
Follow these steps:
1. Go to the Linksys website at http://www.linksys.com and download the latest firmware.
2. To upgrade the firmware, follow the steps in “Appendix D: Upgrading Firmware.”
