19
4 Press the PF-1 key or hold the PF-1 or PF-2 key to program
the new function onto the desired key.
• A tone sounds after pressing the PF-1 key, confi rming that the
function has been stored to the PF-1 press operation.
• Two tones sound after holding the PF-1 key, confi rming that the
function has been stored to the PF-1 hold operation.
• Three tones sound after holding the PF-2 key, confi rming that
the function has been stored to the PF-2 hold operation.
• The press operation of the PF-2 key cannot be reprogrammed.
Attempting to do so causes an error tone to sound.
5 Repeat steps 2 and 3 to reprogram additional functions.
6 Hold the PTT switch for 3 seconds to save the settings and
exit Setting mode.
Note: The transceiver will automatically return to normal operation if
no action is performed for 20 seconds.
PROGRAMMABLE FUNCTIONS
■
None
No function is programmed for the key.
■
Low Transmit Power
Press to toggle the transmit power between high and low.
■
Monitor
Press this key to deactivate QT or DQT signaling. Press the
key again to return to normal operation.
■
Scan
Press this key to turn the Scan function on and off.
Scan is useful for monitoring signals on the transceiver
channels. When scanning, the transceiver checks for a
signal on each channel and only stops if a signal is present.
If the QT/DQT matches, the transceiver stops at the channel
and opens the squelch so you can listen to the call. If the
QT/DQT does not match, the call is ignored and scanning
continues.
