3-10 COOLING SYSTEM
Water Pump
Water Pump Shaft Removal
•
Remove:
Right Engine Cover (see Engine Right Side chapter)
•
Remove the circlip [A], and pull off the primary gear [B].
Special Tool - Outside Circlip Pliers: 57001-144
KX65A6F ∼:
•
Remove the primary gear [B] (see Engine Right Side
chapter).
•
Pull out the water pump shaft [C] toward inside of the right
engine cover.
Water Pump Shaft Installation
•
To prevent the oil seal lips from peeling, apply a molybde-
num disulfide grease [A] to the water pump shaft [B] and
insert it into the oil seals [C] from the inside of the right
engine cover [D].
CAUTION
Be sure to apply a molybdenum disulfide grease
to the water pump shaft when installing. If it is in-
stalled dry, the seals may wear excessively.
•
Replace the circlip for the primary gear with a new one.
Special Tool - Outside Circlip Pliers: 57001-144
•
Instal the impeller and check to see that the impeller turn
freely.
OilSealRemoval
•
Remove:
Impeller (see this chapter)
Right Engine Cover (see Engine Right Side chapter)
•
To remove the oil seals. Insert a metal rod into the right
engine cover from the opposite s ide of the impeller, and
tap evenly around the bottom of the seal.
[A] Metal Rod
[B] Oil Seals
[C] Tap
[D] Ball Bearing
Oil Seal Installation
CAUTION
If the oil seal or ball bearing is removed, replace all
of them with new ones at the same time
•
Be sure to replace the oil seals.
