500.bok : 50003 57 Fri Sep 11 14:52:16 1998
57
C H A P T E R 3 Standard Configuration
Changing the forward
delay expiry time
To change the time between port states while the bridge attempts to
become the root:
1 Select Device Setup or Stack Setup.
2 Click Spanning Tree.
3 Click Forward Delay Timer Expiry.
4 Type the required number of seconds.
5 Click OK.
Changing the state of the
ports
To specify that all ports are using Spanning Tree Protocol:
1 Select Device Setup or Stack Setup.
2 Click Spanning Tree.
3 Click Enable All Ports.
The ports are able to resolve problematic network loops using
STP.
4 Click OK.
Changing the Setup of the
Port
Purpose You can configure the port to operate in different ways, according to
your network’s requirements:
•
Change the port state
•
Select the auto-negotiation mode
•
Change each port to half or full duplex
(If auto-negotiation is not enabled)
•
Specify the speed of the port
(If auto-negotiation is not enabled)
•
Change the forwarding mode of the port
•
Change the flow control setting of the port
•
Specify the spanning tree
