500.bok : 50003 45 Fri Sep 11 14:52:16 1998
45
C H A P T E R 3 Standard Configuration
Local Time
Setting the date and clock
to local time
To change the clock in the switch to your local time:
1 Select Device Setup or Stack Setup.
2 Click Date/Time.
3 Click Insert Current PC Date/Time to show the
present settings. If this is satisfactory, click
OK.
Note The clock displays the time at which it is accessed
and not the current time.
4 If the time or the date is not satisfactory, click the date and/or
time options and type the new time and date.
5 Click OK.
Authentication
Purpose SNMP is a fully defined, interoperative standard that helps you man-
age both the switch and the network. To do this you can:
•
Specify the names of the hosts to access the SNMP agent on the
switch (authentication) by defining the source IP and community
•
Specify read-write or read-only for authenticated hosts
•
Request a trap to be sent if authentication is violated
Note If no hosts are defined in the Authentication List, any host
can access the SNMP agent in the switch.
