15
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
Enter this section by pressing the ENTER/SELECT button. The following screen will appear (although it
may be different for your unit):
G1 indicates you are setting the I/O configuration for
Group 1. The current setting is 1 active output out of a
possible 4 outputs.
Exit With No Change:
You can Exit with no change at any time by pressing the MENU button or simply turning the unit off
Step 1: Select the Number of Outputs:
Use the Keypad to enter a two digit number corresponding to the number of desired outputs. For example,
to set 4 outputs, press the number buttons 04. If you accidentally type in the wrong number, simply re-type
the two digit number.
Confirm your entry by pressing the ENTER/SELECT button. The following screen will appear (although
it may be different for your unit):
G1 indicates you are setting the I/O configuration
for Group 1. The current setting is 1 active input
out of a possible 12 inputs.
Step 2: Select the Number of Inputs:
Use the Keypad to enter a two digit number corresponding to the number of desired inputs. For example, to
set 12 inputs, press the number buttons 12. If you accidentally type in the wrong number, simply re-type the
two digit number.
Confirm your entry by pressing the ENTER/SELECT button.
Step 3: Other Groups:
If you have configured your unit with more than 1 Group, proceed with assigning the number of Inputs and
Outputs for the other groups as in steps 1 and 2.
When you reach an I/O Configuration for a Group that does not have any boards assigned to it, the screen
will read
Undefined. Proceed through all other groups by pressing the ENTER/SELECT button.
After Group 6, the screen will say
DONE and the PATHFINDER will save the information. The unit will
then reset itself and go into the PATH Config section.
