English - 51
MENU FUNCTIONS
Charging station range
There may be reasons to reduce the range of the
charging station in rare cases. It may be necessary if for
instance the charging station is placed close to a bush
or wall which prevents the robotic lawnmower from
docking with the charging station despite making contact
with the charging station’s signals. In these cases, it is
normally better to move the charging station, but if this
is not possible, the range of the charging station can be
reduced.
Use the left and right arrow keys to select range.
Setting Range
Min 0 m
Average approx. 3 to 4 m
Max approx. 6 to 8 m
IMPORTANT INFORMATION
The charging station’s range must only
reduced in exceptional cases. It is normally
better to move the charging station to
a better place in the working area.
Overview
This function summarises the selected settings for each
search method. It is also possible to test that the robotic
lawnmower can follow the guide wires and the boundary wire
to the charging station and dock with it without a problem.
Overview > Test
Testing selected settings can be seen as a natural part of
the installation.
To test the selected settings:
1. Place the robotic lawnmower about 3 metres from
the wire to be tested (boundary wire or one of the
guide wires), facing the wire.
2. Use the right/left arrow key to select Test under
the wire to be tested. Press OK.
3. Press START and close the display hatch.
Check that the robotic lawnmower follows the
guide wire all the way to the charging station and
that it docks with the charging station. The test
is approved only if the robotic lawnmower is able
to follow the guide wire the entire distance to the
charging station and docks at the rst attempt.
If the robotic lawnmower is unable to dock on
the rst attempt, it will automatically try again.
The installation is not approved if the robotic
lawnmower needs two or more attempts to dock
with the charging station.
3012-1099
3012-1247
3012-1243
