Grizzly G1033X Manual

A SERVICE OF

next previous





Figure 29. 

Table

Table

Head

Head

Parallel Parallel

Not-Parallel Not-Parallel

FRONT BACK



     Figure

29







    

      



Table Parallelism Inspection











       

        



      

       



Table Parallelism Adjustments



      

 



To adjust the table parallelism:

1.     



2.   



3. 

Chain TensionPage 28

4. 



5. 





 Note: If the left side of the table is too high,

the left two sprockets will need to be adjusted.

Each tooth on the sprocket represents 0.016"

of vertical movement as the cogs are turned.

Make sure, as you turn the sprockets, to keep

an accurate tooth count to ensure that the

table is adjusted equally.

6.      









NOTICE

When making adjustments, tighten fasten-

ers after each step to ensure the accuracy

of your tests. When adjusting the chain

sprockets, keep in mind that if the chain

becomes too loose, it will fall off of all the

sprockets. Returning it to its proper loca-

tion can be frustrating.