Ez Access 12101 Manual

next previous

Page | 5

INSTALLING RAMP HANGERS AND RAMPS

2.1.

Locate two Ramp Hanger Pairs (MRHP). Install two ramp hangers (one pair) onto each “long” side

of the angle platform where ramps will attach. Place ramp hangers approximately 32” apart (FIG. 2).

2.2.

Hold the ramp hanger to the platform side rail as shown in FIG 2, and then bring the ramp hanger

upward until its “hook” is under the lip in the platform side rail.

2.3.

With continuing upward pressure, push the bottom of the ramp hanger against the platform side rail,

then release, allowing the ramp hanger to slip down and rest inside the ledge at the bottom of the

platform side rail (FIG. 2).

FIG. 2