A SERVICE OF

logo

Open as PDF
next previous
Page | 12
6.
SECURE RAMPS TO PLATFORMS:
6.1.
After all ramps and platforms have been positioned and all handrails and/or connectors, and end
loops have been installed, ramps must be secured to platforms with ramp clips (included in MRHP -
RAMP HANGER PAIR).
6.2.
Use two ramp clips at all locations where a ramp meets a platform.
6.3.
Position ramp clip so that the long side is as close as possible to the ramp side rail and with the clip
edge extends onto the ramp side rail by approximately 5/16″ (FIG 5.1).
6.4.
Drill 1/8″ pilot holes centered on the ramp side rails and 5/16″ from the edge of the platform side rail,
and then use the 1/4″ x 1″ long self-drilling, self-tapping screw to secure the clip to the platform side
rail.
FIG. 5.1