A SERVICE OF

logo

ISM 482 Integrated Scaling Matrix Switcher • Maintenance and Modifications 68
4. Position the DVI card above connector J14 with the DVI connector facing toward the
rear of the switcher. Ensure that the pins on the DVI card properly align with the J14
connector to prevent bending the pins.
5. Carefully mate the 45-pin connector on the DVI output board with connector J14 on the
main circuit board (see figure 52).
DVI Output Card
Mated to the
Main Board via
Connector J14
DVI Output Card
DVI Connector on
DVI Output Card
Figure 52. Output DVI Board Installation
6. Secure the DVI card to the rear panel with the two screws removed in step 3.
7. Close the switcher (see “Opening and Closing the Switcher,” starting with step 9 on on
page 65).