3-31CrossPoint 450 Plus and MAV Plus Switchers • Operation
Example 8: Recalling a preset
The following steps show an example in which a preset is recalled to become the
current configuration. The steps show the front panel indications that result from
your action.
1. Press and release the Esc button (figure 3-47).
C O N T R O L
PRESET
ENTER
ESCVIEW
Press the Esc button to clear all selection
s.
The button flashes once.
Figure 3-47 — Clear all selections
2. Press and release the Preset button (figure 3-48).
1 2 3 15 16
17 18 19 31 32
I
N
P
U
T
S
PRESET
All input buttons with
assigned presets light red.
(Preset Assigned)
ress and release the
reset button.
he Preset button lights.
Unlit
Figure 3-48 — Enter Recall Preset mode
3. Press and release the input or output button for the desired preset
(figure 3-49).
1 2 3 4 15 16
17 18 19 20 31 32
I
N
P
U
T
S
C O N T R O L
PRESET
ENTER
ESC VIEW
ress and release the Input 1 button.
he button blinks red to indicate that this
reset number is selected but not recalled.
The Enter button blinks
to indicate the need to
recall the preset.
= Blinking button
Figure 3-49 — Select the preset
Figure 3-42 on page 3-29 shows the presets associated with the various input
and output buttons for all three front panel configurations.
