Dell M1530 Manual

A SERVICE OF

next previous



4. Ground yourself by touching one of the metal connectors on the back of the computer.



5. Remove the M2 x 3-mm securing screw.



6. Remove the FCM or UWB card.



Replacing the FCM or UWB



1. Insert the FCM or UWB connector at a 45-degree angle into the system board connector labeled "FCM" or "UWB."



2. Press the other end of the FCM or UWB down into the slot on the system board until the card clicks into place.



3. Replace the M2 x 3-mm securing screw.



4. Secure unused antenna cables in the protective mylar sleeve.



5. Replace the cover and tighten the captive screws.

Back to Contents Page



NOTE: If you leave the area, ground yourself again when you return to the computer.

NOTE: In case of an UWB card, disconnect the blue antenna cable from the UWB card.

1

FCM card

2

M2 x 3-mm securing screw

NOTICE: Install the FCM or UWB in the WWAN or WPAN slot. Do not install an FCM or UWB in the WLAN card slot. Doing so may cause damage to your

computer.

NOTE: In case of an UWB card, reconnect the blue antenna cable to the UWB card.