LED Mushroom™ User Manual 15 7/24/2009 4:35 PM
General Troubleshooting
Check fan thermal switch reset
Beam is very dim or
not bright
Clean optical system or replace lamp
Check 220/110v switch for proper setting
Breaker/Fuse keeps
blowing
Check total load placed on device
Check users manual for speed adjustment
Check for power on Mains.
Check device’s fuse. (internal and/or external)
Fixture is not
responding
Check DMX DIP switch settings for correct addressing
Check DMX cables
Check polarity switch settings
Fixture is on but
there is no
movement to the
audio
Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
Lamps cuts off
sporadically
Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
Light will not come
on after power failure
Some discharge lamps require a cooling off period
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables
or black lights.
Check 220/110v switch for proper setting
Re-install bulb, may have shifted in shipping
Bounce mirror motor may have shifted during shipping,
readjust
Check slip ring & brushes for contact
Install bulb
Call service technician
Check reset switch
Check cable connections
Make sure connector is firmly connected to device
All Chauvet lighting fixtures featuring stand-alone
functions do not require additional settings, simply
power the fixture and it will automatically enter into this
mode
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location on the next page.
