67
Shoot with the master camera linked to slave cameras as follows.
1
Set up the master camera.
Configure the settings on the master camera
following steps 1-3 on the preceding page, and
then select [Master].
2
Select [Auto connect].
For [Manual connect] instructions, refer to page
71.
3
Switch to setting up the slave cameras.
On the slave cameras, select [OK].
4
Check the number of slave cameras.
X On the master camera LCD monitor, the number of
slave cameras detected is displayed.
5
Establish the connection.
On the master camera and all slave cameras,
select [OK].
X A screen confirming the connection of the camera
is displayed.
Settings information is stored on the cameras. It is
not stored on the transmitters.
Basic Linked Shooting
