A SERVICE OF

logo

KL9108 / KL9116 User Manual
128
5. Slide the rear attachment sliding brackets along the slide bars until they
contact the rear of the switch, then use the screws supplied with this
package to attach the bars to the rear of the switch (tighten the screws all
the way).
6. Slide the switch open and closed a couple of times to be sure that it is
properly aligned and operating smoothly. (See page 19 for opening and
closing procedures.)
7. After determining that the switch is properly lined up and operating
correctly, finish up by fully tightening down the partially tightened front
attachment screws inserted in Step 4.
Phillips I head
M4 x 6