A SERVICE OF

logo

4 - 4 Ethernet RMON MultiProbe Module Installation and Operation Guide
Module does not
power up
Module is not fitted
correctly against
backplane.
Remove the module from
the slot and replace it in
the slot. This action
ensures that the module
is fitted correctly.
Place the module in a
different slot in the hub.
The hub is not
receiving electrical
power.
Check that the hub is
receiving power.
Test for power at the wall
outlet by plugging in
another device.
Select another outlet on a
different circuit if
necessary.
Module is unable to
communicate with
hub backplane.
Reset the RMON
MultiProbe Module
through the
management module or
press the Reset button on
the RMON MultiProbe
Module front panel.
Table 4-2. Troubleshooting Malfunctions (Continued)
Symptom Possible Cause Corrective Action