For example, to display configuration information about the 6412M-25-TP module in slot
2, you would enter the following command:
ONcoreATM> show module 2 verbose
Slot Install Connect Operation General Information
-------------------------------------------------------------------
2 Y Y Y ONcore 12-Port 25 Mbps ATM I/O Module
status: connected / hardware okay
enable / normal
P/N:xxxxxxx EC level:xxxxxx Manufacturer:xxxx
Operational FPGA version : 1
Backup FPGA version : 1
Type Mode Status
-------------------------------------------------------------------
2. 1:UNI enabled UP-OKAY
2. 2:UNI enabled UP-NO ACTIVITY
2. 3:UNI enabled UP-NO ACTIVITY
2. 4:UNI enabled UP-OKAY
2. 5:UNI enabled UP-OKAY
2. 6:UNI enabled UP-OKAY
2. 7:UNI enabled UP-NO ACTIVITY
2. 8:UNI enabled UP-NO ACTIVITY
2. 9:UNI enabled UP-NO ACTIVITY
2.1 :UNI enabled UP-NO ACTIVITY
2.11:UNI enabled UP-NO ACTIVITY
2.12:UNI enabled UP-NO ACTIVITY
2.13:NOT INSTALLED
ONcoreATM>
If the value for port status indicates that the port is inoperational or not functioning
properly (for example, NOT IN SERVICE or NO ACTIVITY), refer to the chapter called
"Troubleshooting", in the
ONcore ATM Switch/Control Module Installation and User's
Guide
, Document Number 17-00616.
For more information on the SHOW MODULE command, see the Command Reference
Guide.
3-4 25 Mbps ATM Module - Installation and User's Guide
