To set individual port parameters, enter the following command at the ATM console
prompt. The parameters may be entered in any order.
SET PORT slot.port mode type flow_control ilmi
slot Slot number of the 6412M-25-TP module.
port ATM port number.
mode enable or disable. Enter disable until the port has been configured.
type Type of interface used: UNI (user-to-network), NNI (network-to-network),
or SSI (switch-to-switch). Default: Last value entered.
flow_control Used to activate or deactivate the ILMI flow control for this port:
FLOW_CONTROL:ON activates ILMI flow control (GFC field of the cell
header)
FLOW_CONTROL:OFF deactivates ILMI flow control.
Default: Last value entered.
ilmi Specifies the ILMI characteristics for this port:
ILMI:NORMAL ILMI active with automatic detection of the
signalling protocol version (UNI 3.0 or UNI 3.1).
ILMI address registration is normally performed.
ILMI:FORCED_SIG_3. UNI 3.0 signalling is forced, and ILMI address
registration active.
ILMI:FORCED_SIG_3.1 UNI 3.1 signalling is forced, and ILMI address
registration active.
ILMI:OFF_SIG_3. UNI 3.0 signalling is forced, and ILMI address
registration inactive.
ILMI:OFF_SIG_3.1 UNI 3.1 signalling is forced, and ILMI address
registration inactive.
Default: Last value entered.
3-2 25 Mbps ATM Module - Installation and User's Guide
