Filter
Top Products
19
Appendix
Parent unit battery
It takes up to 11 hours for the battery pack to be fully charged. When it is fully
charged, you can expect the following performance:
Operation Operating time
While in standby* mode Up to 8 days
* The parent unit is not charging or in TALK mode. There is no sound detected from
the baby unit. The standby time varies depending on the sensitivity level you set, your
actual use and the age of the battery.
The battery needs charging when:
A new battery pack is installed in the parent unit.
The parent unit beeps four times every minute.
The battery pack is properly installed and no battery icon displays on the screen.
LOW BATTERY and ashes on the parent unit screen.
The light ashes on the parent unit.
CAUTION:
To reduce the risk of re or injury, read and follow these instructions:
Use only the battery pack provided or equivalent. To order a replacement, visit our
website at www.babymonitors.vtech.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or call 1 (800) 267-7377.
Do not dispose of the battery pack in a re. Check with local waste management
codes for special disposal instructions.
Do not open or mutilate the battery pack. Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
Exercise care in handling the battery pack in order not to create a short circuit with
conductive materials.
Charge the battery pack provided with or identied for use with this product only in
accordance with the instructions and limitations specied in this manual.
Observe proper polarity orientation between the battery and metallic contacts.
To prevent re or shock hazard, do not expose this product to water or any type
of moisture.
•
•
•
•
•
•
•
•
•
•
•
•