Filter
Top Products
Operating possibilities
BABYPHONE is a portable
product which offers several
operating possibilities to meet
your needs with regards to
mobility or discretion :
- may be installed, preferably in
an elevated position,
- may be attached to your belt,
- may be worn on your wrist,
with the bracelet delivered with
the device.
Imply clip the
receiver to the
plastic support
and position on
your wrist;
attach the
bracelet using
the pin on the
plastic support.
• Put into operation by pressing
the 0/1 button.
Selecting the channels
The transmission principle is that
of radio waves; the two devices
can only function if they are
adjusted to the same channel.
There are 3 different channels;
select the channel which offers
the best reception quality,
depending on the circumstances.
If reception is poor or if you
receive neighbouring noises,
change the transmission channel
of the receiver (at the back of the
device) and that of the transmitter
(under the device).
2 – OPERATING THE BABYPHONE
The transmitter
• ON / OFF = 0/1 BUTTON
Press the 0/1 button : it will put the
device into operation.
If the light is :
- blinking green : the device is on
standby (no noise is detected in the
room),
- constantly on : noise is detected and
transmitted,
- off : neither the battery nor the power
network function,
- blinking red : the battery is down
and the power network is not
connected.
To stop the device, press the 0/1
button again.
• MUSICAL FUNCTION
It helps baby to fall asleep.
Press the button : it triggers a
melody which lasts 4 minutes and
stops automatically.
To stop, press again.
ENG
ENG
1
2
3
1
2
3
• NIGHTLIGHT FUNCTION
Press the button : it triggers the
nightlight which turns off after 10
minutes and lights again as soon
as the child cries.
To stop the nightlight, press the
button again.
The receiver
• ON / OFF = 0/1 BUTTON
Press the 0/1 button : it puts the
device into operation.
- The 1st indicator on the left
blinks green as soon as the device
is operating. If it blinks very
rapidly :
- change the batteries for the
WATCH BABYPHONE model,
- recharge the device for
the DIGITAL WATCH
BABYPHONE model.
To stop the receiver, press the 0/1
button again. All of the indicators
turn off.
• SUPERVISING MODES
There are two supervising modes :
sound and visual (plus a vibrator
function for the DIGITAL
WATCH BABYPHONE model).
V
isual supervision :
The 4 indicators light progres-
sively when the device receives
a transmission. They provide the
amplitude of the noise
transmitted.
Sound supervision :
The sound is adjusted using the
+ / – buttons.
(on the DIGITAL WATCH
BABYPHONE
model, visual
bars indicate
the intensity of
the sound).
• STORING THE RECEIVER
INSIDE THE TRANSMITTER
To transport the device easily and
to optimise its storage, the
transmitter may be lodged inside
the receiver (devices off) :
- Open the back of the transmitter
by pressing the large button at
the top,
- Install the receiver on its bracelet,
- Hook the receiver and bracelet
inside the rear shell, folding the
bracelet carefully.
- Close the
device until
you hear a
“click”.
Clic