Filter
Top Products
100336 Rev. D
VII. Operating Instructions
19
5. Torque all four front nylock nuts to 8 N/M (71
in/lbs).
6. Continue on to rear transit bracket installation.
To Install the Rear Transit Bracket (Figure 8)
1. Install (2) 10mm x 38.5 mm flat head cap screws
through the transit bracket and plastic saddles
continuing screws through holes in frame on the
right side of transport chair. Ensure the curved
portion of the saddles contact the round tubing.
Rear transit brackets are mounted on the inside
of the frame with both rear transit brackets fac-
ing towards the rear.
2. Install saddles and nylock nuts to secure screws.
Hand tighten.
3. Repeat procedure for left side of frame.
4. Ensure both rear brackets are mounted to the
inside side of frame and facing towards the rear.
5. Torque all four rear nylock nuts to 8 N/M (71
in/lbs.).
F. POSITIONING AND GROWTH ADJUSTMENTS
GUIDE
If necessary, a healthcare professional should
make any changes to the positioning and
growth adjustments. These adjustments are
very important to the orthopedic and neurolog-
ical needs of the child. Care should be taken to
make sure they are appropriate.
Use the provided tools to perform the adjustment of
your Mighty Lite.
In general, positioning and growth adjustments should
be done in the following order:
1. Adjust seat
2. Adjust back
3. Adjust pelvic positioning belt
4. Adjust footrest
5.
A
djust head support
6. Make other standard and optional
adjustments needed
7. Check to be sure that all adjustment screws
ar
e tight
8