Filter
Top Products
VII. Operating Instructions
100336 Rev. D
18
D. TRANSIT USE
1. If possible and feasible, the rider should transfer
to the vehicle seat and use the vehicle
restraints.
2. If the mobility base is used for transport, it must
be used with occupant facing forward in the
vehicle.
3. The occupant must not weigh more than 150
pounds.
4. The location of the securement points is shown.
(See Figs. 5, 6)
5. Use only with WTORS that have been installed in
accordance with the manufacturer's instructions
and SAE J2249.
6. Attach WTORS to the securement points in accor-
dance with the manufacture's instructions and
SAE J2249.
7. Attach occupant restraints in accordance with
the manufacturer's instructions and SAE J2249.
NOTE– To obtain a copy of SAE J2249 Wheelchair Tiedown and
Occupant Restraint Systems for Use in Motor Vehicles,
please contact: SAE International on the internet at
www.sae.org/ or by phone at 724/776-4841.
E. TRANSIT OPTION INSTALLATION
Tools Required:
1. 10mm socket & ratchet
2. 4mm Allen wrench
3. Torque wrench
To Install the Front Transit Bracket (Figure 7)
1. Install (2) 10 mm x 38.5 mm flat head cap
screws through the transit bracket and plastic
saddles continuing screws through holes in frame
on the right side of transport chair. Ensure the
curved portion of the saddles contact the round
tubing. Front transit brackets are mounted on
th
e outsi
d
e o
f th
e frame with both front transit
brackets facing forwad.
2. Install flat washers and nylock nuts to secure
scr
ews. Hand tighten.
3. Repeat procedure for the left side of frame.
4. Ensure both front brackets are mounted to the
outsi
de of the frame and facing forward.
5
6
7