Filter
Top Products
XL-MP15H AUS 01-16.fm
5
2009June11
System connections (continued)
Connect the black wire to the minus (–) terminal, and the red wire to
the plus (+) terminal.
Caution:
You can install the speakers either vertically or horizontally. Affix the
cushions (supplied) to the bottom of the speakers to prevent them
from sliding or falling due to vibration.
A sheet of speaker cushions (8 pcs) is supplied with this product.
Use 4 cushions per speaker.
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket.
Note:
Unplug the AC power lead from the wall socket if the unit will not be
in use for a prolonged period of time.
Remote control
Precautions for battery use:
●
Replace all old batteries with new ones at the same time.
●
Do not mix old and new batteries.
●
Remove the batteries if the unit is not to be used for long period
of time. This will prevent potential damage due to battery
leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium battery,
etc.).
●
Installing the batteries incorrectly may cause the unit to
malfunction.
●
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Battery removal:
Open the battery cover and pull up the battery to take out.
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or if
the operation becomes erratic. Purchase 2 “AAA” size batteries
(UM-4, R03, HP-16 or similar).
●
Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit if this
occurs.
●
Keep the remote control away from moisture, heat, shock, and
vibrations.
Check the remote control after checking all the connections (see
pages 4 - 5).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy the music.
■
Speaker connection
●
Use speakers with an impedance of 4 ohms or more, as lower
impedance speakers can damage the unit.
●
Do not mistake the right and the left
channels. The right speaker is the one on
the right side when you face the unit.
●
Do not let the bare speaker wires touch
each other.
●
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
●
Do not stand or sit on the speakers. You
may be injured.
■
Using antislip speaker cushions
■
AC power connection
Red Black
Incorrect
(Vertical position)
(Horizontal position)
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
■
Battery installation
1
Open the battery cover.
2
Insert the supplied batteries according to the direction indicated
in the battery compartment.
When inserting or removing the batteries, push them towards the
battery terminals.
3
Close the cover.
■
Test of the remote control
STAND-BY
STAND-BY
ON
ON
MICRO COMPONENT SYSTEM
MICROCOMPONENT SYSTEM
XL-MP15
XL-MP15
PHONES
PHONES
ON/ STAND-BY
ON/STAND-BY
REMOTE
REMOTE
SENSOR
SENSOR
AUDIO
AUDIO
IN
IN
PRESET
PRESET
0.2 m - 6 m
(8" - 20')
Remote sensor