Filter
Top Products
CAUTIONS FOR USAGE
1. This unit is not explode-proof construction. Never store the materials which cause flammable or volatile
gas and never store the flammable or volatile liquid in the unit.
2. The door glass, inside door panel, and exhaust vent are very hot when the unit is used with high
temperature setting. Never touch such portion directly with the hands.
3. Avoid to open the door when the chamber temperature is more than 100°C as it is dangerous. The
door opening may cause ignition of flammable material or break of equipment resulting from sudden
temperature change.
4. Do not block the air intake vent on the chamber floor by the stocked articles. The blockage can cause
unstable chamber temperature and shorten the heater life.
5. When cleaning, do not use brushes, acids, benzine, thinner, soap, cleaner or hot water. These will
cause discoloring or damage to coated surfaces. On plastic or rubber parts, they will cause
transformation, discoloration or degeneration. Never apply volatile chemicals (like benzine etc.) on plastic
or rubber parts. When neutral detergent is used, be sure to wipe it up thoroughly with a wet cloth
afterwards. Before cleaning the box, refer to page 18.
6. When placing objects inside, remove traces of water as much as possible.
7. When stacking the unit, always use stacking kit available as an optional component.
ENVIRONMENTAL CONDITIONS
This equipment is designed to be safe under the following conditions (based on the IEC 1010-1):
1.Indoor use;
2. Altitude up to 2000 m;
3. Ambient temperature 5°C to 35°C
4. Maximum relative humidity 80% for temperature up to 31 °C decreasing linearly to 50% relative humidity
at 40°C;
5. Mains supply voltage fluctuations not to exceed ±10% of the nominal voltage;
6. Other supply voltage fluctuations as stated by the manufacturer;
7. Transient overvoltages according to Installation Categories (Overvoltage Categories) II; For mains
supply the minimum and normal category is II;
8. Pollution degree 2 in accordance with IEC 664.