Sanus Systems ELM701 Baby Carrier User Manual


 
6901-002026 <02>
13
3
3 mm
(1/8 in.)
12 mm
(7/16 in.)
[02]
[01]
Attach Wall Plate [02] and Anti-tip Strap [01] to Wood Stud Wall
1. Locate stud. Verify the center of the stud with an awl or thin nail or use an edge to edge stud  nder.
2. Level the wall plate [02] and mark the hole locations.
3. Drill pilot holes as illustrated.
4. Tighten the lag bolts [03] only until the washers [04] are pulled  rmly against the wall plate [02].
5. Insert the strap hook (H) into the wall plate [02].
6. Rotate the strap hook (H) so that it is perpendicuar to the wall plate [02].
7. Tighten straps (S).
NOTE: If you need to move your funiture, loosen the straps and then unclip the strap hook (H) from the wall plate [02].
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
Ù Pilot holes must be drilled to a depth of 63.5 mm (2.5 in.), using a 3mm (1/8 in.) diameter drill bit.
Ù Do not over-tighten the lag bolts [03].
Ù Any material covering the wall must not exceed 16 mm (5/8 in.).
CAUTION: