Samson MXP 124 Musical Table User Manual


 
8
Adding Digital Effects (MXP124FX Only)
The MXP124FX features built-in, high quality, 24-bit Multi Effect Processors,
offering 100 studio grade effects presets. The DIGITAL EFFECTS section
features clean Delays, lush Reverbs and multi-effects like Delay + Reverb. The
following details the operation of the internal DSP effects in the DIGITAL
EFFECTS section.
1. Connect a mic or instrument to the desired channel, adjust
the level and equalizer to your liking and make sure the
MAIN MIX fader level is set so you can hear it in your
speakers.
2. Press the effects ON button to activate the digital effects
channel strip.
3. Select the desired effects program using the SELECT control
knob located in the middle of the channel strip. Rotate
the SELECT switch to one of the 100 effects and press to
confirm the selection.
4. Set the effects to MAIN MIX control to the 12 o’clock
position.
5. Use the FX control on the input channel to adjust the level
of signal to sent to the effects. If the Peak indicator flashes
red, the signal is overloading the DSP, lower the channel FX
controls until the indicator no longer lights red.
Note: The signal feeding the FX control is sent after the
channel Fader, so the channel Fader has an effect on that
level, meaning the FX level tracks up and down with the
channel Fader.