Filter
Top Products
4
Box Spring
Mattress
5
5a
Elbow
Upper
Release
Button
7
Installing Your Bed Rail
PAGE 3
4 Insert Under Mattress:
With bed rail in fold down position, insert both support arms
between the mattress and box spring as far as possible.
NOTE: The bed rail should be positioned so that one end is
even with your child’s shoulder when child is lying down
and at least a 9” (22.86cm) gap between the bed rail and
headboard/footboard.
5 Pivot Bed Rail Up:
Press upper release buttons and fully extend support arms.
Rotate panel up and over mattress.
7 Lock Bed Rail:
Grasp side panel handles and press down on each side until green
lock indicator is fully visible. DO NOT OVERLOAD.
Make sure the
bed rail panel is locked in place by pushing forward on it.
NOTE:
ALWAYS be certain that both support arms are firmly and
securely locked into their correct positions during use.
ALWAYS check to make sure that both indicators are fully green and the
lock symbol is visible while child is in bed. No red should be visible.
DO
NOT use this bed rail until successfully completing this step!
CAUTION:
Support foot
6 Lock Support Arms:
Grasp support arm above elbow and insert into support foot
until indicator line on support arm is no longer visible
(Figure 6). Repeat on other side. Make sure the support
arms are locked in place by pulling up on them.
6
Line
Swing Up