Filter
Top Products
1. Place the Sit’n’Stroll
™
in the vehicle forward
facing.
2. Place the lap belt around the front of the
Sit’n’Stroll
™
and position it through the
appropriate forward-facing vehicle belt path.
Click the latch plate into the buckle.
3. Push down firmly on the Sit’n’Stroll
™
to sink it
into the car’s seat cushion while pulling on the
end of the lap belt or shoulder part of the lap/
shoulder belt. You may have to press on one
armrest at a time to get the auto belt tight.
Pull the seat belt as tight as possible across
the unit.
4. Secure the top tether to the vehicle tether
anchor if desired.
5. Rock the Sit’n’Stroll
™
sideways and pull it
forward from the vehicle’s seat to check it is
securely tightened. If it moves away from the
vehicle seat, retighten the vehicle seat belts.
6. If you have tightened the belt and it is still not
secure, move it to another seating location and
repeat steps 1-5. If there is no location in your
vehicle that will securely hold the restraint, do
not use it! Contact your vehicle dealer to have
a vehicle belt installed that will remain tight.
This type of seat belt system stays loose during normal driving. However, they
have special retractors which allow use with child restraints. Read your vehicle
owner’s manual and look for a label on the vehicle seat belt. Note: Not all vehicle
belts with switchable retractors have instructions for securing child restraints on
the vehicle belt.
1. Pull the vehicle belt all the way out. You may hear a ratchet sound as the belt
retracts into the car frame.
2. Follow steps 1-5 in the directions for manually adjusted belts above.
3. Ensure the vehicle belt is securely locked by pulling slowly on the shoulder
portion of the belt. It should remain locked. If it is not locked, allow the car
seat belt to fully retract and repeat.
Be sure the vehicle seat belts are not twisted.Be sure the vehicle seat belts are not twisted.
Be sure the vehicle seat belts are not twisted.Be sure the vehicle seat belts are not twisted.
Be sure the vehicle seat belts are not twisted.
1818
1818
18
Switchable RetractorsSwitchable Retractors
Switchable RetractorsSwitchable Retractors
Switchable Retractors