Filter
Top Products
Step 4.
You are now ready to install your gate in the doorway. Begin by positioning your gate
level and centered in the doorway opening. Pull the 4 Threaded Spindle Rods out of the
ends of the frame Tubes until the Flat Plastic End touches the wall. **If you are using
the Wall Cups then the flat plastic ends of the Threaded Spindle Rods should go into the
Wall Cups that are fastened to your wall. Next, while holding the flat plastic ends of the
Threaded Spindle Rods against the wall, turn the Adjustment Wheels counter-clockwise
until the Adjustment Wheels are up against the ends of the frame tubes as shown in
Diagram D. DO NOT TIGHTEN. Go to Step 5 for Final Adjustment. HELPFUL HINT:
It may be necessary to hold the Threaded Spindle Rod while turning the Adjustment
Wheel to ensure the Threaded Spindle Rod does not turn.
Diagram D.
(5)
Important: Keep these
instructions for future
reference
Gate Instructions
Adjustment Wheel