Filter
Top Products
PA B-21X
STEP 1
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
1A. attach seat frame (B) to lower mainframe (A) using:
2 - (#1) M10X65mm hex head bolt
2 - (#8) M10 washer
2 - (#6) M10 nylon lock nut
1B. attach seat pad (E) to seat frame (B) using:
2 - (#1) M10X65mm hex head bolt
2 - (#9) M10 spring washer
2 - (#8) M10 washer
1C. attach mainframe support (C) to bottom mainframe
(D) using:
2 - (#3) M10X70mm hex head bolt
2 - (#6) M10 nylon lock nut
1D. Attach end caps to end of seat frame (B) and to
both ends of bottom mainframe (D) using:
3 - (#10) 2”X2” end cap
12