Filter
Top Products
Release Notes
ViewStation EX, ViewStation FX, and VS4000, v. 6.0.4
Feature Limitations
Interoperability
In H.320 calls between a Tandberg system running the beta version of the
E4.0 software and a ViewStation FX running version 6.01 software, the
Tandberg system is unable to control the ViewStation FX camera.
However, the ViewStation FX system is able to control the Tandberg
system's camera. This is a Tandberg issue.
The system is unable to place encrypted calls through the Cisco PIX
firewall.
The system cannot make encrypted multipoint calls through the Tandberg
MCU using version 3.0 software.
The system is unable to place encrypted calls through the Ezenia MCU.
The system cannot place encrypted H.323 calls to Aethra VegaStar Gold
systems.
When placing calls through the MGC MCU, the call may be placed
incorrectly if the extension is entered in the number field. The call will be
dialed correctly if the extension is entered in the extension field.
Video may display incorrectly in multipoint ISDN calls through a Tandberg
MCU if the display is configured for discussion mode.
In calls using a RADVision ECS gatekeeper running a software version
before 3.5 and set for routed mode (Call setup Q.931 and Call control
H245), the system may be unable to share content properly. This can be
prevented by setting the RADVision ECS for direct mode.
In some low-speed calls, the system is unable to share content properly
with Tandberg and Sony systems.
Far site mute indications are not available in calls with Aethra VegaStar
Gold systems.
- 8 -