Filter
Top Products
En
7
Connections
Connections
Be sure to set the unit to standby mode and unplug the power cord from the power outlet before making or changing connections between devices.
Connect the power cord after all the connections between devices have been completed.
Be sure to use the power cord, AC adapter and USB cable included with this product.
Refer to the operating instructions for the component to be connected.
For the connection cables, check the position of the unit terminal, and connect correctly to the unit.
This unit can be used by connecting it to a computer using a USB cable, even without connecting the AC adapter.
! Connect this unit and the computer directly using the included USB cable.
! A USB hub cannot be used.
! Connect the computer to which this unit is to be connected to an AC power supply.
! The brightness of the buttons that light is dimmer when using on USB bus power.
! When USB bus power is being used for operations, there will be situations like the following where the unit does not operate using USB bus power.
— The power supply is insufficient for USB bus power.
— When other USB devices are connected to the computer.
— When headphones with an impedance of less than 32 W are connected.
— When headphones are simultaneously connected to the stereo phone jack and the stereo mini-phone jack.
— When a monaural jack is connected to the [PHONES] terminal.
! This unit may restart if the AC adapter or USB cable is disconnected during operation.
Connecting with an iPhone/iPad
For power supply
For audio output
For checking
the output sound
DJ software
For audio input
R
L
R
L
2 3 4 5 6 81 7
To USB port
USB
iPhone/iPad
USB Mobile battery /
USB power adapter
To power
outlet
Headphones
Power cord
(included)
Component, amplifier,
powered speaker, etc.
To headphones
Headphones cord
AC adapter (included)
USB cable (included)
Microphone
To microphone
Microphone cable
Rear panel
Audio input
Side panel
Left
(L)
Right
(R)
Audio cable
iPhone/iPad
connection cable
To audio input
terminals
! This unit can use an iPhone/iPad connection cable to recharge on an iPhone/iPad. The unit can also be recharged while in Standby mode.
! Connect an AC adapter when recharging an iPhone/iPad.
! If power is supplied by USB bus power, iPhone/iPad recharging cannot be performed.
! When the iPhone/iPad power is off, or when residual battery power has been exhausted, iPhone/iPad recharging cannot be performed.