Filter
Top Products
16
Output video display
Why does the video display icker?
• Interference may occur when the parent unit
is out of range of the baby unit. Interference
may also occur if there are too many walls or
ceilings between the parent unit and the baby
unit or when other 2.4GHz wireless devices are
switched on (e.g. microwave, Wi-Fi router). Put
the parent unit in a different place, closer to the
baby unit, or switch off other wireless devices.
• The rechargeable battery of the parent unit
may need to be charged.
Why isn’t there any image on the video display
when the battery/power-on light is on?
• The parent unit may be in the voice activation
mode. Press the voice activation button again to
switch on the video display.
Why isn’t the image on the video display clear?
• The display brightness may be set too low.
Increase the display brightness (see chapter
‘Features’, section ‘Adjusting display brightness’).
• Perhaps you did not remove the protective foil
from the video display. Remove the protective
foil.
Why doesn’t the parent unit work in the voice
activation mode?
• The distance between the baby and the baby
unit may be too large to pick up sounds from
the baby. Make sure that the baby unit is placed
1 to 1.5 metres (3.5 to 5 feet) away from the
baby.
Why isn’t the image on the video display clear
in night vision?
• The distance between the baby and the baby
unit may be too large. Make sure that the baby
unit is placed 1 to 1.5 metres
(3.5 to 5 feet) away from the baby.
• Sometimes it is possible to see a greenish image
when the infrared lights are on. This is normal
due to external factors.