Filter
Top Products
Note: The message ‘Not Linked’ also appears on the display of the parent unit when the baby unit is
switched off.
Menu options
The following functions are operated in the menu of the parent unit.
Menu operation - general explanation
Note: Menu functions can only be operated when a connection has been established between the baby
unit and the parent unit.
1 Press the MENU button to open the menu (Fig. 30).
The rst menu option appears on the display.
2 Use the – and + buttons to select the desired menu option (Fig. 31).
Note: The arrow indicates in which direction you can navigate.
3 Press the OK button to conrm (Fig. 32).
4 Use the + and - buttons to select the desired setting.
5 Press the OK button to conrm.
The new setting ashes twice and then disappears from the display.
6 Press the MENU button again to exit the menu.
Adjusting microphone sensitivity
Note: You can only adjust the microphone sensitivity in the menu of the parent unit.
You can set the microphone sensitivity of the baby unit to the desired level. You can only change the
microphone sensitivity when a connection between the baby unit and the parent unit has been
established, i.e. when the LINK light on the parent unit lights up green continuously.
1 Select ‘Sensitivity’ with the + and - buttons.
2 Press the OK button to conrm.
3 Select the desired microphone sensitivity level for the baby unit with the + and - buttons.
h = minimum sensitivity level
i = maximum sensitivity level
4 Press the OK button to conrm.
The message ‘Saved’ appears on the display.
Note: When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and
therefore transmits more often. As a result, the units consume more power.
Sound alert on/off
Note: You can only switch the sound alert on and off in the menu of the parent unit.
This feature allows you to monitor your baby silently. It enables you to switch off the volume on
your parent unit and still be alerted if your baby cries.
If the sound alert is switched on, the parent unit beeps as soon as the fourth sound level light lights
up while the volume is switched off. In addition, the backlight of the parent unit display goes on and
the sound alert symbol ( g) ashes on the display.
1 Select ‘Sound Alert’ with the + and - buttons.
2 Press the OK button to conrm.
3 If the alert is off, the display shows ‘On?’. Press the OK button to switch on the alert. If the
alert is on, the display shows ‘Off?’. Press the OK button to switch off the alert.
,
,
,
,
,
ENGLISH 15