Filter
Top Products
220-240V AC
250 Watts
between +7cC and +37cC
PTC temperature controlled heating
system
Technical Specifications
Power supply (mains):
Power consumption (mains):
Operational ambient temperature:
Protection:
ENGLISH10
Problem solving
Solution
Turn the click-step control knob 4 to
the right until the indicator lamp lights
up red to start the heating up again.
Check ring filling and start
temperature.
Lower the adjustment setting.
Check ring filling and start
temperature.
Stir the contents from time to time
while heating. Check that the click-step
control knob is in the n position
Wait 15 minutes between consecutive
uses to allow the safety cut-out to
reset.
This is normal; it may turn on or off
while heating.
Shield indicator from ambient light to
improve visibility.
Hard water deposits are normal and
may increase if your water is very
hard; remove the deposits periodically
with white vinegar (see maintenance).
Problem
Temperature too low.
Temperature too high.
The jar has not heated correctly.
Unit does not warm up.
The indicator light switches on and off
while keeping warm.
Indicator light does not seem to light.
The bottom of the tank is spotted.