Filter
Top Products
EN
– Charging will take longer than 16 hours when the parent unit
is switched on during charging.To shorten the charging time,
the parent unit should be switched off.
➜The parent unit is now ready for use!
General notes:
– When the units are switched off, in case of battery operated
use, the batteries still discharge slowly.
– When the batteries are almost empty, the battery check light
of the parent unit (B-6) starts blinking red; the battery check
light of the baby unit (A-8) lights up red continuously.
Place the parent unit in the charging base (B-14) to recharge
the batteries and/or replace the batteries in the baby unit.
Preparing your baby monitor
11
Using your baby monitor
Use this baby monitor for its intended household use as
described in this manual.
1 Place both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press and hold the On/Off (y) button (A-1) on the baby unit
for 2 seconds.
> The night light (A-3) lights up briefly.
> The LINK light (A-2) lights up red briefly then starts
blinking green as it seeks connection with the parent unit.
If, after 30 seconds, no link is established,"Not Linked" will
appear on the display and the LINK light starts blinking red
as it seeks connection with the parent unit.
3 Press and hold the On/Off button (y) (B-5) on the parent
unit for 2 seconds.
> The sound level lights (B-8) light up orange briefly.
> The battery check light ( - B-6) lights up red briefly.
> The LINK light (B-7) lights up red briefly then starts
blinking green as it seeks connection with the baby unit.
> The LINK lights (A-2, B-7) on both units blink green until
connection has been established.This will take up to
approximately 30 seconds. Both LINK lights (A-2,B-7) will
then light green continously.
> If, after 30 seconds, no link is establshed both LINK lights
(A-2, B-7) will light up red and the parent unit will emit a
beep from time to time.
> 1m / 3 ft