Filter
Top Products
EN
7
2 Insert four 1,5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries).
3 Close the battery compartment cover (A-10), using a coin.
➜ The baby unit is now ready for battery operated use.
Parent unit
A rechargeable battery pack has already been installed in the
parent unit.
1 Connect the power adapter cord to the power supply jack
(DC 9V
——<<++
- B-7) of the charging base (B-5).
2 Connect the AC power adapter (B-3) to a wall outlet.
3 Place the parent unit in the charging base (B-5).
> The charging light (B-6) lights up red.
4 Leave the parent unit in the charging base (B-5) until the
batteries are fully charged (at least 14 hours).
> When the batteries are fully charged, the charging light
(B-6) will gradually dim.The parent unit can now be taken
out of the charging base and used cordlessly for up to
10 hours.
> When the POWER light (B-10) flashes red, battery power
is low. Place the parent unit in the charging base (B-5) to
recharge the batteries.
➜ The parent unit is now ready for use!
Getting your baby monitor ready