Philips SC464 Baby Monitor User Manual


 
ENGLISH 9
Problem solving
Problem Possible cause Solution
Power light does Parent Unit: unit is not turned on. Turn VOLUME ON/OFF control
not light downwards.
Power adapter is not plugged in or Plug in power adapter or replace
batteries are exhausted. batteries.
Baby Unit: unit is not turned on. Push power button.
Power adapter is not plugged in or Plug in power adapter or replace
batteries are exhausted. batteries.
High pitched noise Units are too close together. Move Parent Unit away from Baby Unit.
Turn VOLUME ON/OFF control on
Parent Unit upwards.
No sound Volume on Parent Unit is set too low. Turn VOLUME ON/OFF control
downwards.
Power lights red Batteries are low or empty. Replace batteries or connect to mains
power.
Interference or poor Mobile or cordless phones too close. Move phones away from the units.
reception to the baby monitor.
Pick-up from another Both systems are operating on the Switch channels.
baby monitor same frequency.
System check light Units are out of range or there is Move units closer together to restore
flashing (green) / interference from another the link. Remove the other FM source.
System check alarm FM source.
Baby Unit: unit is not turned on. Push power button.
Hereby, Philips Consumer Electronics, B.U. Peripherals & Accessories,
declares that this SBC SC464 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.