Filter
Top Products
Installation
Before connecting the Baby Bottle Warmer to the mains, check to
ensure that the mains outlet is 230V AC.
1 Place the Baby Bottle Warmer out of the reach of children
and on a dry, non-slip, horizontal surface.
2 Turn the click-step control knob 4 to the left to the
‘0’ (OFF) position.
> The indicator lamp lights green.
3 Unreel the required cable length from the cable reservoir 8
and plug into the mains outlet.
Operation
Warming of baby bottles
1 Turn the click-step control knob 4 to the left to the
‘0’ (OFF) position.
2 Connect the bottle warmer to the mains socket.
> The indicator lamp lights green.
3 Fill the beaker with 10 or 20ml water by using the water cup
of the ring 6.The content is depending on the bottle filling
and start temperature (see Heating Overview on page 3).
4 Place the bottle in the middle of the beaker and put the ring
6 on top of it.
5 Use the click-step control knob 4 to set the correct setting
(see Heating Overview on page 3).
> The indicator lamp lights red.
> When the right temperature is reached the indicator lamp
will light green.
6 Remove the bottle from the container and turn the control
knob to the ‘0’ (OFF) position.
ENGLISH 5
SBC SC250_booklet.qxd 02-02-2004 16:04 Pagina 5