Filter
Top Products
Registering a key detector to the unit
Important:
R For key detector supplied users: The supplied key detector has been
pre-registered to the unit.
R Do not install the battery until you activate the key detector registration using the
handset.
R After installing the battery in step 2, the registration mode will end within 30
seconds.
1 Handset:
For key detector 1: MMENUN#6571
For key detector 2: MMENUN#6572
*1
For key detector 3: MMENUN#6573
*1
For key detector 4: MMENUN#6574
*1
*1 If you have 2 or more key detectors.
2 Key detector:
With the tab pushed to the right (A), pull out the battery holder (B). Insert the
battery with (
) facing up (C), t
hen close the battery holder (D).
R Confirm that the battery is set correctly (
, ).
R The
key detector will go into the registration mode automatically and the
registration tones will sound.
C
D
B
A
3 Wait until a long beep sounds.
R Aft
er the key detector is registered, the detector number is displayed.
4 Handset: MOFFN
If the registration tones do not sound or the registration fails, you need to remove
t
h
e
battery from the key detector once to make the key detector available for
registration again. Leave the battery out of the key detector for over 2 minutes,
and then repeat from step 1.
3
Installation
TGA20(en-en)_1201_ver022.pdf 3 2012/12/01 19:54:54