Filter
Top Products
PAGE 16 — WM45HCE PLASTER/MORTAR MIXER • OPERATION AND PARTS MANUAL — REV. #0 (02/04/13)
INITIAL START-UP (ENGINE)
CAUTION
DO NOT attempt to operate the mixer
until the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
This section is intended to assist the operator with the
initial start-up of the mixer. It is extremely important that
this section be read carefully before attempting to use the
mixer in the field.
STARTING THE ENGINE (HONDA ENGINE)
1. Place the engine fuel valve lever (Figure 6) to the “ON”
position.
Figure 6. Engine Fuel Valve Lever (ON Position)
2. Move the throttle lever (Figure 7) away from the slow
position, about 1/3 of the way toward the fast
position.
Figure 7. Throttle Lever (1/3 Start Position)
3. Place the choke lever (Figure 8) in the “CLOSED”
position if starting a cold engine.
Figure 8. Engine Choke Lever (Closed)
4. Place the choke lever (Figure 9) in the “OPEN” position
if starting a warm engine or the temperature is warm.
Figure 9. Engine Choke Lever (Open)
5. Place the engine ON/OFF switch (Figure 10) in the
“ON” position.
Figure 10. Engine ON/OFF
Switches (ON Position)