Filter
Top Products
Belt-Positioning Booster: Without Seat Back Installation
Belt-Positioning Booster: Without Seat Back Installation
1 Place Child in the
Child Restraint
Place child restraint against
the back of the vehicle seat.
Place the child’s bottom flat
against the child restraint and
their back against vehicle
seat.
2 Buckle Child
Place lap belt across child’s
thighs. Lock buckle. The
shoulder belt should cross the
base of the child's neck and
across the chest (not the face
or neck). Pull up on the
shoulder belt to tighten belt
snugly.
NOTE: Make sure the lap and
shoulder belt are placed under
armrests as shown.
NOTE: A snug belt should not
allow any slack. It lies in a
relatively straight line without
sagging. It does not press on
the child’s flesh or push the
child’s body into an unnatural
position.
2 Remove Backrest
Lift the backrest off the seat
base.
NOTE: Backrest needs to
rotate below the seat base.
1 Lower Backrest
Place seat base close to an
edge of a table. Rotate the
backrest down.
WARNING
!
Do not use this child restraint if the midpoint of your child's
head is above the top of the vehicle seat back or vehicle
headrest.
Use only the vehicle’s lap and shoulder belt system when
restraining the child in this booster seat.
Check vehicle instructions for more information about air
bag/child restraint use.
Do Not Use only the lap belt when using this seat.
The shoulder belt must always be adjusted snugly across
the child’s chest.
NEVER place the shoulder belt under the child’s arms or
behind child’s back.
Failure to follow these warnings could cause serious injury
or death to your child.
15
16
continue on next page
4358-4583 US Rodi XR 8/26/08 11:41 AM Page 17