Filter
Top Products
- 12
First installation
If the reception conditions are good, then a room antenna may be used for
DVB-T. Passive and active room antennas are available on the market. The pow-
er is supplied for an active antenna via the antenna connection. For automatic
programming or in "TV Menu – Connections – Antenna DVB – Antenna DVB-T,"
the distribution voltage (5 volts) is to be set correspondingly.
It may be practical to use a nondirectional antenna. If the location is outside the
normal transmitting range, then a unidirectional antenna may also be used to
improve the reception quality.
You can fi nd out more on the digital stations that can be received in your area
at your specialist dealer.
If a set was retrofi tted with a PIP tuner or if this is already integrated in a set
with a digital recorder, then plug the antenna into the antenna input of the PIP
tuner and connect the PIP tuner output with the ANT-TV socket (Tuner 1). See
illustration on page 7.
Set-specifi c equipment and retrofi tting options for PIP and satellite tuners, see
pages 46 and 47.
If a Digital Satellite Tuner 1 has been retrofi tted, connect your satellite antenna
system to the ANT-SAT socket.
If a Digital Satellite Tuner 2 has been retrofi tted, connect one antenna cable
each, for example from the antenna switch or from the twin LNC, to both SAT
sockets.
When laying the cable, use the cable clips affi xed beneath the TV set.
Replace the connection cover on the TV set.
Handling the fabric hose
Use the fabric hose included to lay
the mains cables, antenna cables
or cables from other electronic
components systematically; then
lead the hose with the cables to
the connection boxes. This provides
you with an elegant solution when
laying cables.
The diameter of the fabric hose increases when you push it together lengthwise
(see illustration). This makes it easier for you to push through cables with plugs.
Using the conditional access module
In order to be able to receive encrypted digital stations, the conditional access
module (CA module
(1
) and the smart card
(1
both have to be inserted into the
corresponding slot of your TV set. You can fi nd the slot common interface (CI-
Slot) on the back of your TV set, see the illustration on pages 6/7.
1. Make sure the TV set is switched off with the mains switch on the set.
2. First push the smart card into the CA module as far as it will go. Insert it so
that the side with the golden
contact chip faces the side
of the module printed with
the supplier‘s brand logo.
Printed arrows indicate how
to insert the card. Also follow
the installation instructions
included with the smart card.
3. Slide the CA module carefully into the slot with the
contact side facing the front. The logo on the CA
module should be visible.
Make sure the module is not twisted in the process.
Do not use force.
When the module locks, the eject button is pressed
outwards.
(1
The CA module and the smart card are not included
in the scope of delivery for this set; you can usually
obtain them at your specialist dealer.
Switching on
Press the mains switch (for Spheros R 37, the set switches on immediately, the
green indicator lamp lights up).
For Spheros R 26/32:
The red indicator on the set now lights up (standby mode).
Switch on the set using the switch integrated in the indica-
tor. The green indicator on the set now lights up (for further
operating options see page 14).
Contact side
Eject button
CA module
CI-Slot
Downloaded From TV-Manual.com Manuals