Filter
Top Products
49
206-4213
Remote Jack Pack Setup
RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093
RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE
to 001). See Installer Menu detailed descriptions for further information.
TV Connections
Make these connections ONLY after Master TV Setup and TV cloning procedures are
complete.
Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP
INTERFACE port on the TV’s rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio
connectors, as applicable, for the cable bundle.
Remote Jack Pack / TV Connections & Setup
RGB IN (PC)
ANTENNA/
CABLE IN
TV-LINK
CFG
AUDIO IN
(RGB/DVI)
SPEAKER
OUT(8Ω)
PTC SERVICE
(SERVICE ONLY)
/
DVI
IN
1
2
..........
RESET
UPDATE
RJP
INTERFACE
GAME CONTROL
/MPI
RS-232C
(SERVICE & EXT POWER)
..........
VIDEO
L/MONO-AUDIO-R
AV IN
L R
DC IN
HDMI/DVI IN 1
Connect HDMI connector
from RJP cable bundle.
RJP INTERFACE
Connect RJ-45 Control
cable from RJP cable
bundle.
RGB IN (PC)
Connect RGB connector from RJP
cable bundle (legacy RJP only).
AUDIO/VIDEO IN
Connect Composite Video/Audio
connectors from RJP cable bundle.
(Composite Video on legacy RJP only.)
093 RJP AVAILABLE 001
Note: DC IN connector on rear jack panel of 26LT670 only.