Filter
Top Products
Center gate in opening. Gaps on each side
should be equal.
Place hinge spindles (I) over hinge bottom
posts (c), dropping them into place. Adjust
latch spindles out until they fit securely into
the two locking brackets. Latch spindles
must be adjusted so they click under locking
latch when in closed position.
Space between end of gate and mounting
surface should be no less than 1” and not
more than 4” on each side.
Check that gate can be easily opened and
closed without catching.
Place a spring (k) and hinge cap (d) on each
hinge post. This may require some manipula-
tion to ensure hinge posts fit and holes line
up. Insert remaining screws and tighten. With
wrench (q) tighten lock nuts on all spindles
towards gate.
WARNING: The spring must be placed
OVER hinge spindle and hinge cap must
be installed as directed.
7